What happens if you put too much litter in Litter-Robot The four-part system (base, globe, bonnet, and drawer) was constructed with easy upkeep in mind. Depending on your personal preference and your cat’s behavior, we recommend deep cleaning your Litter-Robot approximately three times per year. It’s important to keep your Litter-Robot clean so that it continues to work effectively.
Red timing light litter robot full#
You should perform a full cleaning and litter change every one to three months. If you have more than one cat, you will typically need to empty the waste drawer twice per week. If you have one cat, you should empty the waste drawer once per week. Thank you! How often should you change Litter-Robot? If it is, please empty it out and dispose of the waste properly. Additionally, please check the waste pouch and make sure that it is not full. Please make sure to check the litter inside the globe and ensure that it is not above the raised fill line.
If these troubleshooting steps don’t fix the issue, please contact customer service for further assistance. Once it’s on, the device should automatically reset itself. Then, reassemble the globe and bonnet.īe sure to position the internal shield and key correctly before powering the device back on. Next, situate the base so that it’s level and all four feet are touching the ground. If your Litter-Robot 3 isn’t working properly, don’t despair! There are a few simple troubleshooting steps you can take to get it up and running again.įirst, power down the device and then disassemble the bonnet and globe. Bleach should be avoided, as it can damage the plastic. Wiping it down with a damp paper towel will remove any dirt and grime, and using a mild detergent will help to keep it looking new. Then, tilt the bonnet top away from the back of the car and lift it up and off.Ĭleaning your unit regularly is important to maintain its appearance and longevity. To open the bonnet on your car, first press in the tabs on the left and right sides of the front of the bonnet. How do you remove the bonnet litter in Robot 4 Once the globe in waste for are thoroughly rinsed, you can use a mild soap if desired. See you just push them both and release the bonnet Like that you have to make sure to be carefulĪnd again, never use harsh chemicals on your litter robot. How do you disassemble a Litter-Robot 3 globe? Flip the unit over and unscrew the baseplate. Take out the gearbox from the motor assembly.ĩ.Remove the feet from the bottom of the unit.ġ0. Remove the sensors from the motor assembly.Ħ. Unscrew the motor assembly from the bottom of the unit.ĥ. Remove the access panel on the back of the unit.Ĥ. Disassembling your Litter Robot is quick and easy to do, and can be helpful when you need to clean the unit or make repairs.Ģ. The clean litter is then returned to the litter box, while the waste is deposited into a covered waste drawer that can be easily emptied when full. It is a automatic, gravity-operated system that uses clumping cat litter to sift and separate waste from clean litter. Litter Robot is a self-cleaning litter box for cats.
Let the machine do its usual start-up cycle.Wait for 10 seconds then plug it back in. You will know this if you see a solid blue light (not flashing). Ensure that the globe is in the Home position.
Red timing light litter robot how to#
Litter Robot App Not Working? Here’s How To Hard Reset Litter-Robot: What do you do then? Resetting Litter-Robot might be the trick. Sometimes, if you don’t put it back correctly after cleaning, you might have issues with the yellow light flashing and the globe not completing its full cycle rotation. There’s nothing like receiving your first Litter-Robot III! However, it’s definitely a bummer if you see that dreadful yellow light flashing.
0 kommentar(er)
